ANTOK Signature · Installation
Install with confidence and care.
Follow the six-step wall-mount sequence illustrated in our general user manual.
Explore the complete user manual ↗The mirror contains fragile glass. Protect yourself from cuts and keep children away during installation. Styles and rear mounting brackets may vary.
This is a general guide. Use only the placement method supported by your actual mirror. A freestanding position requires a built-in support. Before drilling, confirm that the wall, fixings and mounting points are suitable for the mirror; ask a qualified installer if you are unsure. The manual does not specify wall load ratings, drill sizes or screw-head clearance measurements.
Check the accessories.
The general manual illustrates 3 expansion anchors and 3 screws (labelled “EXPANSION SCREWS*3” and “SCREWS*3”). Its hanging sequence uses two rear mounting points. Check the actual contents and mounting brackets supplied with your mirror before starting.
The six installation steps.
- Measure the mirrorMeasure the distance between the two mounting brackets on the back of the mirror. Bracket styles may vary.
- Mark the wallTransfer the measurement to the wall and mark the two drilling points at your desired height.
- Drill the holesDrill holes at the marked points using a suitable drill bit.
- Insert wall anchorsGently tap the wall anchors into the drilled holes until they are flush with the wall.
- Install the screwsDrive the screws into the anchors, leaving the screw heads slightly exposed for hanging.
- Hang the mirrorCarefully hang the mirror on the screws and check that it is secure and level.
Other placement options.
The manual illustrates leaning placement and, for full-length models with a built-in support, freestanding placement. Not every mirror supports every option. Check the actual model before choosing.
See the illustrated placement options